ThinkGeo Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Advanced Style ======
**X Offset** - Sets the X offset of this style. A positive X offset will draw the style that many pixels to the right of the actual feature. A negative X offset will draw the style that many pixels to the left of the actual feature.

**Y Offset** - Sets the Y offset of this style. A positive Y offset will draw the style that many pixels below the actual feature. A negative Y offset will draw the style that many pixels above the actual feature.

**Start Cap** and **End Cap** - For lines thicker than 1 pixel, the Start Cap controls how the beginning of a line is capped, and the End Cap controls how the end of each line is capped. The following cap types are available:

^Option ^ Description ^ Example ^
| Flat | Applies a flat cap. | {{wiki:Cap - Flat.png}} | 
| ArrowAnchor | Applies an arrowhead cap that is larger than the line thickness. | {{wiki:Cap - ArrowAnchor.png}} | 
| DiamondAnchor | Applies a diamond-shaped cap that is larger than the line thickness. | {{wiki:Cap - DiamondAnchor.png}} | 
| Round | Applies a rounded cap. | {{wiki:Cap - Round.png}} | 
| RoundAnchor | Applies a circular cap that is larger than the line thickness. | {{wiki:Cap - RoundAnchor.png}} | 
| Square | Applies a square cap. The effect is that the line appears slightly extended. | {{wiki:Cap - Square.png}} | 
| SquareAnchor | Applies a square cap that is larger than the line thickness. | {{wiki:Cap - SquareAnchor.png}} | 
| Triangle | Applies a triangular (pointed) cap. | {{wiki:Cap - Triangle.png}} | 

**Line Join** - Determines what type of joint to draw at the point where one line ends and another begins. The following joint types are available:

^Option ^ Description ^ Example ^
| Miter | Joins lines with a mitered (sharp) edge. | {{wiki:Line Join - Miter.png}} | 
| Bevel | Joins lines with a beveled (squared off) edge. | {{wiki:Line Join - Bevel.png}} | 
| Round | Joins lines with a rounded edge. | {{wiki:Line Join - Round.png}} | 
**Miter Limit** - The maximum distance that a mitered joint can extend from the endpoints of a line. Reducing the miter limit may produce clipped corners. Only applies if a Line Join of "Miter" is selected.

**Drawing Level** - Forces this style to draw on a specific drawing level. The GIS Editor has a set of internal drawing levels that can be used to set rendering priority for certain styles. For example, labels are set to use the highest drawing level by default, so that they always appear on top of other map features regardless of what layer they're on. This enables you to add styles to any layer without worrying about them being covered up by other layers above them.

Map Suite UI Controls

MapSuite GIS Services

Free Tools

Professional Services

Support & Learning

About ThinkGeo

User Tools

Site Tools

Page Tools

Map Suite UI Controls

MapSuite GIS Services

Free Tools

Professional Services

Support & Learning

About ThinkGeo